How to Install Limestone Fireplace Surrounds
Limestone fireplace surround is a good way to finish renovating or installing a new fireplace. Display of natural stone will add a lot of character to the room and draw attention to the beauty of the fireplace. Homeowners now enjoy the convenience of pre-fabricated fireplace. However, these are usually sold without any kind of surround or resolve them. Limestone fireplace surround is perfect for finishing off the fireplace is more modern. This is what should be done if you want to install a limestone fireplace surrounds you.
Tools and Materials Needed:
* Tape measure
Rate *
* Trowel
* Wet look
* Pahat
* Rubber mallet
* 4 2 of Lumber
* Foot
* Hammer
* Limestone sheet
* Stress fracture membrane
* Thinset
* Sponges, cloth, buckets
Step 1 – Plan Your Fireplace Surround
Using a piece of graph paper and pencil, plan how you want to see you around the fireplace. You do not have very detailed at this time, but the placement of a limestone base, and how far it will surround your fireplace are a few considerations. Take more measurements and take them to the hardware store where you bought your piece of limestone.
Step 2 – Preparing the Surface
Before doing any work around the fireplace to be willing to accept different materials. Cleaning different surface in the vicinity of the fire and dry completely. After you clean the surface to be sure everything was level. If you have any low spots on the floor, or dips in the wall, there are several levels above the thinset.
Step 3 – Install Membrane Stress Crack
Around the fireplace, you will find at least two different materials. Metal from the furnace itself and Drywall walls. They are both hot in different levels and can cause cracks in thinset and limestones. A stress fracture membrane will help to keep things even to eliminate problems with the heating process.
Step 4 – Put in Order Nutritional Limestone
The first place to begin is the fireplaces. Starting in the middle of the fire and began to spread a thin layer of thinset. Use a notched spades and spread enough to receive some slabs of limestone. Setting the lime into the thinset and give a little wiggle in order to create a stronger bond. Press the lime with the rubber hammer to remove any air bubbles and keep the stage. Continue to install the limestone in the furnace room leaving 1 / 8 inch between each slab.
Step 5 – Limestone Cut to Fit
There will be instances where you need to cut the limestone plate. Use a wet saw with diamond blade to cut their hearts after the measurement was made.
Step 6 – Install Limestone Wall
By using the same method of installation of the limestone in the furnace, the furnace began to settle around the limestone wall by installing sheet. Use a timber to hold the limestone so as not to fall before the thinset has time to bond and fix.
Step 7 – Seal Limestone Fireplace Surround
You surround is not finished until you nuts seam of limestone and then seal it. Mix the grout according to directions and spread over the surface to fill all the gaps and seams. Deleting an edge. Allow grout to dry and then apply the sealer. Once there were two layers of limestone you can enjoy your work.