How to Use Electrical Wire Connectors
Connecting the power cord is a common and easy way to splice two wires carrying electrical currents together. Unlike many electric cable project, to install electrical cable connector is easy enough for non-professionals to perform and requires very little equipment. It is important to note that although there are various types of wire connectors. Some crimp on, while others are just pictures on. The steps below describe how to use the most common kind: twist-on wire connector.
Tools That You Probably Need
* Wire Stripper
* Wire Cutter
* Electric Wire Connector
Step 1 – Turn Off Power
To avoid dangerous electrical shock always turn off the power before working on each project and cables.
Step 2 – Choose the Right Connector Wire Size
Almost as important as the power-off, choosing the right size wire is connected to work can prevent electrical failure and prevent electrical fires. The reason for this is that when a switch or device is switched on, it causes an electric current flowing through the cables and wires into the connector. Having now reached the lead, he finds the light on the flow resistance. The game itself cause the cable to heat up a bit which, in turn, causes them to expand. Once the switch is turned off again and the flow was stopped, the cable will cool and contract again to their normal size. If the wrong size cable connector has been implemented, it may pop off when the wire expands or contracts only when the wire fell. Either way, the conductor of the cable will be left open, which potentially could cause all kinds of problems. To choose the right size extension cord, looking at the side where the connector and make sure that the connector is used to measure the position of the wire is connected to and also to the number of conductors of the wire.
Step 3 – Strip to Be On Wires
Using a wire stripper, remove the layer around the ends of two cables to be connected. Not inches more than 3 / 8 layers that need to be eliminated.
Step 4 – Put the Two Together stripped Ended
Line up the two wires so they are parallel to each other. Some power cables will play together before putting the connectors on them. There is no harm in doing this, however, to be UL-registered (which means the test has been approved by the board of safety) connector to make firm connections without wires to play, so it uses a wireless connection will play works well. In fact, playing along the cable before installing the connector can make improvements in the future that is more difficult due to splice two wires will be more difficult to separate.
Step – 5 Attach the connector during Ends of Wires
Is the cable bend or just marching in line with any place, other parts of the conductor wire connector cap hit from two wires. Check to ensure that no material is exposed condutor protruding from the bottom connector. If some wires are not exposed to prominence, remove the lid and clips from some of the end with wire cutters and try again.
Step 6 – Twist the Connector On
After covering the entire cable connector is open, turn the connector clockwise until it feels very tight. Finally, test the quality and strength of coupling to hold the lead and tried to pull every wire is not strong. Remember, if the lead wire is not strictly possible, the cap may slip off as described in step 2 and cause problems.