Installing Crawl Space Vent Covers
During the summer months, covering a large crawlspace ventilation to keep air flowing through the lower house. Air movement is important to keep a low condensation and allows air to cool the floor. There are several ways to close the hole covers you during the winter to keep your home more energy efficient.
Winter problems
Winter weather can be a major cause of damage to your home if you do not take the fall to cover your crawlspaces. Ventilation in the crawlspace along the wall works great for the summer. In winter, however, they can mean a damaged pipe, cold floors and higher energy bills. Vent installation includes more than crawlspace vents will save money by avoiding unnecessary services and high heating bills.
Wide range of options
There are many different methods that homeowners can use to close the vents in the crawlspace. Some of these methods use simple common ingredients, while others require some work to get them to close the vents.
Styrofoam Pieces
One of the more popular materials used to manufacture the plastic covering the hole. Many modern homes will have some holes in the plastic cover over their crawlspaces. If you have a plastic vent you can easily cover them with styrofoam blocks. Blocks are very easy to install, but should be posted in or covered with a piece of plastic that was shot over the edge of the hole channel.
Organic Materials
For those who have large feet with some trees, use of organic materials to solve two problems:
* You can remove the leaves that fall in the winter by filling plastic bags with them.
* You can close the ventilation with the bag is filled with layers of leaves. It makes great environmental isolation and did not cost anything to do.
Plywood Rectangle
Many houses with crawlspaces will be ventilated timber. This is best covered by a sheet of plywood with some insulation between the winding holes and plywood. The best part about using a rectangular plywood as a ventilation cover is that they can be reused each year. Simply delete them and save them for the summer months.
Plastic
In areas where temperatures do not get below freezing consistently ready to stand with the builders. Black plastic will cover the hole to make the best if trimmed to fit the hole and held in place with a bar a few inches. plastics may not be used again, but will work to protect your water pipes if there is no longer available.
Wind is the Enemy
When it comes to close ups of your crawlspace ventilation covers, the most important thing to remember is that it should be air tight. Any amount of wind to sneak through the gap closing can cause pipes to freeze at very cold temperatures. Even if a small amount of air gets through the hole covers can be quite cold channel. If it is near, or in, water pipes, it will freeze very quickly.